No Products in the Cart
The perfect material to make wood stickers with! The wood veneer is available in White Maple, Red Oak or Cherry Wood, the perfect tones to capture dark details for a high contrast engraving. There's some flexibility with the grain pattern so it can be used on flat to curved surface. Be sure to keep that in mind when engraving as you will want to lay your material in the proper grain direction depending on which way you want the material to bend. Comes with 3M sticker backing that is laser safe. The veneer is unfinished and can be stained/finished. Grain and Color appearance variation can be expected from sheet to sheet and lot to lot, it will vary from what is pictured because it is a natural wood product.
If using outside or if you want to extend the life of your sticker, I would suggest using a clear coat or shellac after engraving to seal the wood.
I keep them flat on the bed with magnets for consistency.
Grain and color may vary as this occurs naturally in wood.
Material can be cut down with scissors easily if you wanted to split into smaller sized sheets.
Sheets are 12"h x12"w +\- 1/4” and .024" or 0.61mm thick.
Recommended Engraving Settings
You can use the profile "thin maple veneer"
55w: 150mm/s @ 13% Power - Engraving
20mm/s @ 25% Power - Cutting